What's new

News Headlines

HowTo Tips Chinese Diesel Heater Error Codes E01 - E10 All Codes, Faults & Fixes

  • Thread starter DC
  • Start date
  • Replies 0
  • Views 151
How To
DC

DC

Admin
Staff member
Administrator
Moderator
V.I.P Member
Registered
LV
15
 
Joined
Jan 1, 2022
Messages
1,542
Reaction score
39
Points
4,065
Awards
3
Location
Doncaster
Cash
£0.00
Watch Video here


00:00 - Intro
00:15 - ERROR CODE 01
01:25 - ERROR CODE 02
01:49 - ERROR CODE 03
02:16 - ERROR CODE 04
02:36 - ERROR CODE 05
03:00 - ERROR CODE 06
03:47 - ERROR CODE 07
04:33 - ERROR CODE 08
06:41 - ERROR CODE 09
07:22 - ERROR CODE 10

ERROR CODE 01
This is a low voltage error code that can be caused by a few things

Low battery - Charge battery

Volt drop - Wire heater direct to battery via inline fuse and if you need to extend your power cable to reach the battery use 6mm2 cable.

As an Amazon associate, I earn from qualifying purchases.

6mm2 RED CABLE - https://amzn.to/3XMAgYR
6mm2 BLACK CABLE - https://amzn.to/3IzEeQf

Controller set to wrong voltage - Check it is set to 12v not 24v in menu settings. password 1688

Damaged battery - Replace battery
DECENT AGM LEISURE BATTERY - https://amzn.to/41cGYdJ



ERROR CODE 02
This is a very simple one to explain, error code 02 is a high voltage error code.

Check that your 240v to 12v transformer is set to 12v if you are using one
Make sure your batteries are wired in parallel rather than series if you have multiple batteries.



ERROR CODE 03
This is a glow plug error code so most likely replace your glow plug

As an ebay partner I earn from qualifying purchases

REPLACEMENT GLOW PLUG - https://ebay.us/JmHxwE
GLOW PLUG REMOVAL TOOL -https://amzn.to/3ElpNwq
REPLACEMENT GLOW PLUG MESH - https://ebay.us/38C8Lp

It could also be a battery with damaged cells - Replace battery/batteries
ANOTHER DECENT QUALITY AGM BATTERY



ERROR CODE 04

Bad connection - Check all connectors are clipped into place correctly, check the pins inside make contact

Stuck piston - Give the pump a light tap a few times on start up

PUMP REPLACEMENT - https://amzn.to/3xAII2F



ERROR CODE 05

This is an overheating error code

Heat outlet - check that there is nothing obstructing your vents

Ducting - Check for blockages, harsh bends and that nothing has crushed it in

Fan side of heater - make sure there is a gap for the heater to suck in cool air, if there isn't enough cool air flowing over the heater it will overheat



ERROR CODE 06
This is a fan error code

Fan - make sure nothing is lodged in the fan
Fan - make sure the casing isn't pushing against the fan restricting it
Fan - make sure both magnets are firmly in place
Fan - poor build quality, send it back for replacement

TRICLICKS 5KW - https://amzn.to/3XIWPh4
AMBIENCO 2KW - https://amzn.to/3XS9n60



ERROR CODE 07

Broken controller - replace controller

BLACK 5 BUTTON REMOTE - https://ebay.us/f5hjuX
BLUE 5 BUTTON REMOTE -
BLACK 3 BUTTON REMOTE 2KW -

Incompatible controller - replace controller and motherboard

Bad connection - Check all connections of the blue cable that runs from remote to motherboard. even the solder on controller and motherboard or replace all

3/5KW MOTHERBOARD - https://ebay.us/Igld6M
2KW MOTHERBOARD - https://ebay.us/qsLb4H

WIRING LOOM 3/5KW - https://amzn.to/3KhOoGs




ERROR CODE 08
This is a fuel system fault

New install - The heater needs priming before starting it

Run out of fuel - Make sure you have not run out of fuel, if you have you will need to prime the heater again

Low on fuel - If you have tapped into vans fuel tank and van is LOW on fuel fill it up

Air bubbles in line - Check pump angle, loose fuel clips, don't drive with heater running, change to the correct fuel line

DECENT FUEL LINE



ERROR CODE 9
This is a faulty sensor code

Faulty sensor - Replace sensor
OVERHEAT SENSOR REPLACEMENT

We have also heard stories of the heat sensor not fixing the 09 error code and the actual thing that did fix it was a new controller for some reason. So if the heat sensor does’t fix the problem try a new controller.
Please see above



ERROR CODE 10
This is a multiple failed attempts error code

So any of the above more than one time, most likely EO8

or

Flooded - blow into air intake when the heater is starting up

IF YOU WOULD LIKE TO BE ENTERED INTO OUR MONTHLY VAN LIFE PRIZE DRAW WITH SOME AMAZING VAN LIFE PRIZES PLEASE SUBSCRIBE TO OUR BRAND NEW PATREON ACCOUNT FOR £3 A MONTH. YOU WILL AUTOMATICALLY BE ADDED TO THE PRIZE DRAW EACH MONTH...
https://www.patreon.com/Donclassifieds
 
Last edited:
Back
Top Bottom